- Author
-
Bentz, D. P.
|
Peltz, M. A.
|
Winpigler, J. A.
- Title
- Early-Age Properties of Cement-Based Materials. Part 2: Influence of Water-to-Cement Ratio.
- Coporate
- National Institute of Standards and Technology, Gaithersburg, MD
- Journal
-
Journal of Materials in Civil Engineering,
Vol. 21,
No. 9,
512-517,
September 2009
- Keywords
-
cements
|
water
|
compressive strength
|
hydration
|
water content
|
temperature effects
|
cracking (fracturing)
|
heat release
|
deformation
|
cement pastes
|
chemical reactions
|
shrinkage
|
mortar
|
temperature rise
|
portland cement
|
calorimetry
- Identifiers
- cement oxide composition and bogue potential phase mass fractionsas provided by the cement manufacturer; mortar mixture proportions used in the study; compressive strength results for mortar cubes; isothermal calorimetry and setting characteristics; semiadiabatic temperature; autogeneous deformation; net autogeneous shrinkage strains at 7 d for the four mortar mixtures
- Abstract
- The influence of water-to-cement mass ratio (w/c) on early-age properties of cement-based materials is investigated using a variety of experimental techniques. Properties that are critical to the early-age performance of these materials are tested, including heat release, semiadiabatic temperature, setting time, autogenous deformation, and strength development. Measurements of these properties using a single cement are presented for four different w/c, ranging from 0.325-0.425. Some of the measured properties are observed to vary widely within this range of w/c ratios. The heat release and setting time behaviors of cement pastes are contrasted. While early-age heat release is relatively independent of w/c, the measured setting times vary by several hours between the four w/c investigated in this study, indicating the fundamental differences between a physical process such as setting and heat release, which is purely a quantification of chemical reaction. While decreasing w/c certainly increases compressive strength at equivalent ages, it also significantly increases autogenous shrinkage and may increase semiadiabatic temperature rise, both of which can increase the propensity for early-age cracking in cement-based materials.