- Author
- Burch, D. M. | Licitra, B. A. | Zarr, R. R.
- Title
- Comparison of Two Test Methods for Determining Transfer Function Coefficients for a Wall Using a Calibrated Hot Box.
- Coporate
- National Institute of Standards and Technology, Gaithersburg, MD
- Journal
- Journal of Heat Transfer, Vol. 112, 35-42, February 1990
- Keywords
- walls | calibrated hot box | test methods | heat transfer | transfer function | transient thermal performance | air temperature | interior surface | concrete blocks
- Abstract
- This paper experimentally verifies and compares two dynamic test methods for a calibrated hot box to characterize the transient thermal performance of complex walls. In these methods, a wall specimen is sandwiched between the two conditioning chambers of a calibrated hot box. The exterior surface of the wall specimen is subjected to a time-varying excitation function in air temperature. At the interior surface, the air temperature is maintained steady, and the heat transfer response is measured. Conduction transfer function coefficients that relate the measured heat transfer response to the excitation function are derived. The two dynamic test methods were applied to an insulated hollow concrete block wass that contained significant thermal bridges and lateral heat flows. Empirical transfer function coefficients derived by the test methods predicted with good agreement the heat transfer response of this wall specimen when its exterior surface was subjected to excitation functions that differed markedly from those used to derive the coefficients.