FireDOC Search

displaying 1 - 10 results in total 11

  • Simiu, E.; Heckert, N. A.; Filliben, J. J.; Johnson, S. K.
    view article (1.0)

    Extreme Wind Load Estimates Based on Gumbel Distribution of Dynamic Pressures: An Assessment.
    National Institute of Standards and Technology, Gaithersburg, MD
    Structural Safety, Vol. 23, No. 3, 221-228, 2001

  • Simiu, E.; Filliben, J. J.
    view article (1.0)

    Statistical Analysis of Extreme Winds. Final Technical Note.
    National Bureau of Standards, Washington, DC
    NBS TN 868, June 1975,

  • Rossiter, W. J., Jr.; Vangel, M. G.; Kraft, K. M.; Filliben, J. J.
    view article (1.0)

    Performance of Tape-Bonded Seams of EPDM Membranes: Effect of Material and Application Factors on Peel Creep-Rupture Response.
    National Institute of Standards and Technology, Gaithersburg, MD
    NIST BSS 176, May 1997, 59 p.

  • Simiu, E.; Changery, M. J.; Filliben, J. J.
    view article (1.0)

    Extreme Wind Speeds at 129 Stations in the Contiguous United States. Building Science Series.
    National Bureau of Standards, Washington, DC; National Climatic Center, Asheville, NC; National Science Foundation, Washington, DC; Department of Energy, Washington, DC
    NBS BSS 118, March 1979, 324 p.

  • Simiu, E.; Filliben, J. J.
    view article (1.0)

    Design Gust Wind Speeds in the United States.
    National Institute of Standards and Technology, Gaithersburg, MD
    Journal of Structural Engineering, 1077-1080, September 1999

  • Zarr, R. R.; Martinez-Fuentes, V.; Filliben, J. J.; Dougherty, B. P.
    view article (1.0)

    Calibration of Thin Heat Flux Sensors for Building Applications Using ASTM C 1130.
    National Institute of Standards and Technology, Gaithersburg, MD; National Center of Metrology, Queretaro, Mexico
    Journal of Testing and Evaluation, Vol. 29, No. 3, 293-300, May 2001

  • Zarr, R. R.; Filliben, J. J.
    view article (1.0)

    International Comparison of Guarded Hot Plate Apparatus Using National and Regional Reference Materials.
    National Institute of Standards and Technology, Gaithersburg, MD
    NIST TN 1444; NIST Technical Note 1444, May 2002, 87 p.

  • Filliben, J. J.; Gurley, K.; Pinelli, J. P.; Simiu, E.
    view article (1.0)

    Fragility Curves, Damage Matrices, and Wind-Induced Loss Estimation.
    National Institute of Standards and Technology, Gaithersburg, MD; University of Florida, Gainesville; Florida Institute of Technology, Melbourne, FL
    Computer Simulation in Risk Analysis and Hazard Mitigation, 3rd (Third) International Conference. Proceedings. June 19-21, 2002, Sintra, Portugal, 119-126 p., 2002

  • Zarr, R. R.; Filliben, J. J.
    view article (1.0)

    International Study of Guarded Hot Plate Laboratories Using Fibrous Glass and Expanded Polystyrene Reference Materials.
    National Institute of Standards and Technology, Gaithersburg, MD
    Insulation Materials: Testing and Applications. Volume 4. ASTM STP 1426. 2002, ASTM International, West Conshohocken, PA, Desjarlais, A. O.; Zarr, R. R., Editors, 3-16 p., 2003

  • Pnelli, J. P.; Simiu, E.; Gurley, K.; Subramanian, C.; Zhang, L.; Cope, A.; Filliben, J. J.; Hamid, S.
    view article (1.0)

    Hurricane Damage Prediction Model for Residential Structures.
    Florida Institute of Technology, Melbourne, FL; National Institute of Standards and Technology, Gaithersburg, MD; Florida Univ., Gainesville; Florida International Univ., Miami, FL
    Journal of Structural Engineering, Vol. 130, No. 11, 1685-1691, November 2004